cobra spoiler swap question

[JAA55]

will the cobra spoiler cover the holes left from the stock GT? will the outside holes line up with the mounting points of the stock GT spoiler? Thanks

 

[Mustang928]

Well with my OEM 93 cobra wing.. There are 2 holes exposed on the drivers side.

 

[JAA55]

i thought that might be the case, the hole for the third brake light wiring looks pretty far out to be covered by the cobra spoiler

 

[Mustang928]

Its really not that bad... I'm going to use washers from home depot and paint them red.

Don't mind the dirt... blew my engine AGAIN
View attachment 308210
View attachment 308211

 

[dbdragracing]

Did you have to drill any holes in your trunk lid to go from the GT to the Cobra spoiler? If so, did it come with a template? Thanks.

 

[Mustang928]

No template, its an OEM 93 cobra wing. You can make one, just tape regular paper and place it underneath the wing and trace it. The only hole I drilled was for the brake light wires, its no biggie. I decided not to drill the holes for the middle part of the wing, since the stock holes hold the wing in place just fine.