• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

Cold Startup Problem (First time)

  • Thread starter Thread starter brtnstrns
  • Start date Start date Nov 22, 2009

brtnstrns

Member
Dec 19, 2003
606
11
19
Lewisville, TX
Nov 22, 2009
#1
  • Nov 22, 2009
  • #1
This morning I started up my car after it sitting overnight and when I started it up the RPMs dropped down below 500 or so and then it stalled out immediately. The car would not stay on unless I held the throttle down. This is the first time this has happened since I've had the car (about 1 month) and it wasn't particularly cold outside this morning, probably around 68 or 70 degrees. Well I drove the car about 3 miles back to my apartment (it was in a garage that it could get towed in) by braking with my left foot and holding the throttle at 1000 RPMs at stop lights so that it wouldn't stall out. By the time I got back to my apartment, about a ten minute drive, the car was fine: I let my foot off the gas and it stayed idling like normal. This obviously isn't a huge issue since the car stayed on after being warmed up a few minutes but what could I look at to ensure the car won't have any cold-start problems in the future?
 

wmburns

SN Certified Technician
Aug 14, 2009
5,892
514
204
Houston Texas
Nov 22, 2009
#2
  • Nov 22, 2009
  • #2
Possible IAC problem.

Basically the same problem as GDawg (same diagnostic procedures).

http://www.stangnet.com/mustang-forums/800824-high-idle-anyone-wmburns.html

Do you have a ODB2 scanner to monitor the IAC percent? Turn the AC on/off and verify that the percent changes.

Consider cleaning the IAC (although it may only be a temparary fix). Clean the MAF.

Note, my 2000 manual will sometimes dies when cold. Usually happens when coasting to a stop immediatly after pulling out of a parking space. It does it infrequently so I just ignore it.
 

brtnstrns

Member
Dec 19, 2003
606
11
19
Lewisville, TX
Nov 22, 2009
#3
  • Nov 22, 2009
  • #3
wmburns said:
Possible IAC problem.

Basically the same problem as GDawg (same diagnostic procedures).

http://www.stangnet.com/mustang-forums/800824-high-idle-anyone-wmburns.html

Do you have a ODB2 scanner to monitor the IAC percent? Turn the AC on/off and verify that the percent changes.

Consider cleaning the IAC (although it may only be a temperary fix).
Click to expand...

Sorry I don't know what the IAC is. That thread seems to be about high idling problems whereas mine was just temporarily stalling out at idle. There was no jump in RPMs or anything, it was just that I would turn it on and if I didn't press the gas down it turned itself off. Then 10 minutes later it was fine.
 

wmburns

SN Certified Technician
Aug 14, 2009
5,892
514
204
Houston Texas
Nov 22, 2009
#4
  • Nov 22, 2009
  • #4
IAC= Idle Air Controller. Trouble shooting an IAC is the same (high or low idle). Except with high idle it is higher possibility of problem being a vacuum leak. With low idle it is more likely to be the IAC itself.

The IAC is on the throttle body. Follow the 1/2" line from the intake tube to the the throttle body. Some Mustangs have a square piece mid way in the bypass tube.

The PCV line goes from the right hand valve cover to the TB.

It is a long shot, but excessive EGR flow could cause idle problems. There shouldn't be any EGR flow when cold. However, one would expect it to happen more frequently than just when cold.

Consider cleaning the MAF. Use cleaner designed for the MAF.
 

scupking

Active Member
Sep 18, 2005
1,186
1
36
Enfield, CT
Nov 22, 2009
#5
  • Nov 22, 2009
  • #5
Replace your IAC. My car did this a few years back. Replaced the IAC and it was all better.
 
You must log in or register to reply here.

Similar threads

E
2007 GT Stalls when lights or a/c turned on
  • ejscarfo
  • Jun 22, 2026
  • 2005 - 2009 Specific Tech
Replies
2
Views
186
2005 - 2009 Specific Tech Jun 29, 2026
ejscarfo
E
Hard to start when engine is cold
  • 86_Capri
  • Mar 11, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • 2
Replies
32
Views
1K
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jun 21, 2026
CAMTWO1070
P
2000 GT Random Power Loss
  • Pinellas50
  • Mar 9, 2026
  • SN95 4.6L Mustang Tech
Replies
4
Views
339
SN95 4.6L Mustang Tech Mar 23, 2026
Pinellas50
P
7
Engine Random hanging idle
  • 706 Saleen
  • Feb 11, 2026
  • Fox 5.0 Mustang Tech
Replies
9
Views
710
Fox 5.0 Mustang Tech Feb 19, 2026
86HO5.0
8
F
2004 Mustang GT – Fuel Pump Not Priming
  • Fayio
  • Apr 22, 2026
  • SN95 4.6L Mustang Tech
Replies
7
Views
371
SN95 4.6L Mustang Tech Apr 27, 2026
n0v8or
N
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?