I am new to the site (i am usually on clickclickracing.com or austinareastangs.com) but I look forward to being a member here because the tech/ parts review section is something I feel is better here.. anyway, heres the deal.
I have an 89 LX Vert with an AOD. My mods so far are: Mac 1 5/8 shortys, 2 1/2" O/R X pipe, Flowmaster dumps, Electric fan, B&M shift kit (which sucks!), K&N box type filter, C&L 73mm MAF, removed air silencer and bumped timing to 14* running 93 octane. I went to the track (san antonio raceway) and ran a pitty 15.54@91.15mph. The car has 16" pony wheels with sticky 245s (w rated). I cut a 2.35 60 with NO tire spin flash launching the car and then tried foot braking it running the same time again. Its obvious I need a better stall and some 4.10's (this isnt my daily). I am building this car on a budget ( I just had twin girls two months ago) and need advise on the build parts. I am planning thumper E7s w/ TMOSS intakes and either a B cam w/ 3000 stall (FRPP makes one thats 2200-3000 stall depending on mods with balooning plates on pump and cover with needle bearings). or I am thinking about another alternative, a custom grind by Buddy Rawls. I am trying to hit the 13's N/A and maybe add an S trim or some nitrous to hit 11's occasionally. Please give me your IMOs about this set-up as this is the first 5.0 i've built (last car was a 97 cobra that got rear ended by a Diesel Dodge w/ cattle guard who had NO insurance so I sue'd and bought the 5.0. Sorry this post is so long - its really appreciated.
I have an 89 LX Vert with an AOD. My mods so far are: Mac 1 5/8 shortys, 2 1/2" O/R X pipe, Flowmaster dumps, Electric fan, B&M shift kit (which sucks!), K&N box type filter, C&L 73mm MAF, removed air silencer and bumped timing to 14* running 93 octane. I went to the track (san antonio raceway) and ran a pitty 15.54@91.15mph. The car has 16" pony wheels with sticky 245s (w rated). I cut a 2.35 60 with NO tire spin flash launching the car and then tried foot braking it running the same time again. Its obvious I need a better stall and some 4.10's (this isnt my daily). I am building this car on a budget ( I just had twin girls two months ago) and need advise on the build parts. I am planning thumper E7s w/ TMOSS intakes and either a B cam w/ 3000 stall (FRPP makes one thats 2200-3000 stall depending on mods with balooning plates on pump and cover with needle bearings). or I am thinking about another alternative, a custom grind by Buddy Rawls. I am trying to hit the 13's N/A and maybe add an S trim or some nitrous to hit 11's occasionally. Please give me your IMOs about this set-up as this is the first 5.0 i've built (last car was a 97 cobra that got rear ended by a Diesel Dodge w/ cattle guard who had NO insurance so I sue'd and bought the 5.0. Sorry this post is so long - its really appreciated.