Connecter Views For 95 5.0

[02stang351w]

Hello
Was wondering If anyone out there has the Pinout/Diagrams for the 3 connectors in the RH Cowl/Kick Panel. I do believe C259 is one of them,just cant track the others. Currently Mid project and my dang fan wont turn on and no gauges work. Don't see a reason for the fan not to turn on cause of the connectors but i know i only got a few pins worth of wires hooked up and that fan is dead still. pls send me help!
btw the pcm connector is not needed!
OoO ok fine i forgot it , its a 95 mustang gt with a 5.0L 5 speed a/c and erm u dont even want to know what its shell is

 

[Adam95GT]

ill post pics of the evtm tomorrow for you if you dont get them b4 then

 

[TrueBlue95GT]

Try this site:

Mustang FAQ - Engine Information

 

[02stang351w]

That site helps a bit but it lacks the connector views that i need. Too many backwards wires to follow to figure out if its just a simple ground/power out that comes from inside the body that it needs to operate. i know that the sensor/ccrm/fan/pcm was good when i started the project, never cut a wire between the ccrm and the pcm. i have put the new fan plug on the end where the old fan plug was thats it, but it was same 3 wire setup high low and ground. When i ground the pcm wire that runs the high speed fan mode it works so i know its gettin ground/half its power to the ccrm at least. when i ground the one thats supposed to work the fan on low speed it does nothing at all. eh yeah thats why i asked for simple connector views.
ramblings, sorry just spent another 8 hrs under the fender playin wire tag