Convertible Rear Window Alignment

B

benea

New Member

Oct 20, 2007

0

0

0

Columbus, MS

Oct 20, 2007

#1

• Oct 20, 2007

• #1

I know everyone knows what a pain the rear windows on the convertible are but does anyone have a clue as to the best way to get them aligned so they will come up with the top up? I have to raise the windows first and then put my top up, otherwise the windows will jam against the back of the window track. So of course I can't put them down either unless I drop the top.

 

N

n2o-89fox

New Member

Oct 8, 2007

116

0

0

ca

Oct 20, 2007

#2

• Oct 20, 2007

• #2

mine are somewhat that way. 1 rear window I have to put up before the top goes up but they will both roll down just fine with the top up.

 

Repostyle

Member

Jun 11, 2005

538

0

16

Portland, OR

Oct 20, 2007

#3

• Oct 20, 2007

• #3

I have just the opposite problem, I can't have my rear windows up before I put the top up, they don't end up in the tracks. They go up and down fine with the top up, but one side kind of rolls up the weatherstripping at the top as the window tilts forward, I just need to re-glue that piece to fix that.

I'm guessing it's just not sliding in the weatherstripping like it should, how old is your weatherstripping? If it's new you might think about some kind of lube, if they're old you might just replace the rear pieces, they might just be worn out and hanging the window up.

 

stykthyn

I want to measure mine. It doesn't look that tall.

15 Year Member

Jul 6, 2006

5,232

2,652

223

gainesville

Oct 21, 2007

#4

• Oct 21, 2007

• #4

take off the 1/4 panels and grease the tracks. if the windows havnt been used in a while sometimes rust and dirt will cause the windows to stick. there are also some shims that are held in with bolts or phillips head screws, I cant remember which that will allow you to adjust to the left or to the right. You will also want to check the trim that is attached to your top and holds the windows when the top is up. there are 2 10mm bolts that hold them in and they sometimes come loose and will allow the trim piece to move not allowing your window to go up or down properly.

 

T

Topdowncruise

New Member

Apr 7, 2005

207

0

0

Canada

Oct 21, 2007

#5

• Oct 21, 2007

• #5

A good investment is a Ford factory book they put out in '83 that applies to '83 to '89 vert tops and how to adjust them.Lots of diagrams etc.I got mine on ebay for about $12 I think.It has helped a lot.

 

stykthyn

I want to measure mine. It doesn't look that tall.

15 Year Member

Jul 6, 2006

5,232

2,652

223

gainesville

Oct 22, 2007

#6

• Oct 22, 2007

• #6

I have that book too, I did not find it that helpful, but it is still better than nothing. the best bit of info I found in there was how to adjust the alignment on the frame.

 

B

benea

New Member

Oct 20, 2007

0

0

0

Columbus, MS

Oct 26, 2007

#7

• Oct 26, 2007

• #7

Thanks for the input!