Has anyone with magnaflow x-pipe CA cats (#337338) had a muffler shop modify the lower hanging passenger side? That side hangs low enough that it often gets scraped over speed bumps. My mech and I took a look at it on the lift and there doesn't seem to be enough space to place the cat higher toward the engine; between the engine and chassis. And if we place the cat further down, it might be too close to the oil pan. We were worried about heat off of the cat effecting the oil temp, is that a reasonable concern?
If anyone could post a picture of how they’ve rerouted that cat it’d be greatly appreciated.
Thanks in advance,
If anyone could post a picture of how they’ve rerouted that cat it’d be greatly appreciated.
Thanks in advance,