couple of questins

this is what i did to fill my trans fluid and it was fool proof. first release the bottom plug to drain the fluid and then replace the plug. then the top to fill it up, it should only take a little less than 3 quarts of dextron 3 or merkon 3. to do this i went to my local hardware store and bought about 6 feet of half inch clear tubing. i then jimmy rigged it into fitting into an old funnel i had by cutting the tip at an angle. from there i snaked the tubing through the engine compartment down towards the trans. i stayed under the car to wait for it to come out of the top hole to let you know its full. it was a very easy project.