Couple of Turbo questions????

http://www.turbomustangs.com/

will have all the info you need on them. lots of reading though

i'm sure somebody will give you an answer here though

donjohn said:

http://www.turbomustangs.com/

will have all the info you need on them. lots of reading though

i'm sure somebody will give you an answer here though

Click to expand...

I agree, it sounds like you have a TON of research to do!


You CAN make your own headers, or buy them.

If you have the welder ( TIG is your best bet here), grinder, chop saw, tools, ect, and the time, then go for it. Makes it even easier if you have a spare motor on the engine stand.
I have made a few single kits now, and the twin setup im currently going to run, and I have learned alot from this set of headers.. It's a great learning experience, if you have the time and tool. Not all that difficult, as I would say the hardest part was actually coming up with the design. As for the pipes, you simply buy the J or U bends and cut them to size, by fitting and mocking up. most of the time if you buy J bends, you do not need to buy straight pipe, or very much of it.

Otherwise www.bgturbokits.com sells the twin turbo headers fairly cheap. As for turbos, you should do the research to size them correctly for your application. IE: Cubic inches, rpm, engines powerband, type of driving/racing,ect.

make them yourself. It makes life easier when you can put everything exactly where you want it. Just be sure to add supports to what you make to help prevent cracking