Cowl Hood Install

I just picked up a 4" cowl hood for my '91 LX yesterday and when I layed it on the car it doesn't sit right. The length and width is good and it lines up at the front and back, but it doesn't seem to arc down as much as the stock hood. When its all lined up at the hinge end, the front of the hood sits a few inches too high. Since the hood is fiberglass I could make it fit the contour of the car perfectly, but with pressure applied to the front and back. I'm taking the hood to get installed and painted by my buddy's bodywork guy and was wondering if any of this would be a problem or if it will fit when latched down with pins? Thanks

I'm going to take some pictures of it tonite when I get home from work and I'll post them then. The rubber stoppers aren't getting in the way of it closing, the hood just seems to be a little bit warped or twisted in the middle section causing alignment issues at the front.