Crane 2031 cam install on a 95 Cobra Questions

I got the phone # from SGS on their website. I tried calling and the # is no longer in service. I even double checked to make sure I was right. The other place got back to me and quoted 700. They will also do two pulls on the dyno to make sure the A/F is ok at no extra charge. I will probably end up going with them.

BaBysARM said:

go to smallblockposse.com talk to some people on site. Lots of folks up there that street race and can point you in the right direction as far as a reputable shop.

Click to expand...

Thanks, but I think I'm going to go with the place that did my last tune. I don't think I will find anyone much cheaper that will also check to make sure my car has a good A/F ratio. Most shops charge $65-$70 an hour anyway. A lot of people were saying it shouldn't take too long to do this cam swap, but they aren't just swapping out the cam. They also need to check and replace pushrods, valvesprings, gaskets and replace the timing chain. If they are quoting me $700, that means they expect it to take around 10 hrs. to do. For all the work that is involved, I think that estimate is dead on.