Crate Engine!!

markc522

New Member

Apr 4, 2005

23

0

0

dfw

Jun 7, 2005

#1

• Jun 7, 2005

• #1

im getting ready to drop the ball on a crate engine and i was wanting your opinions on what to get.
here is what i want.

320 to 350 horse (it will be a daily driver)
i want the mass air (mine is speed density)
i want to spend no more than $3500 (im broke )
where should i go to get this? (im in dallas tx)

am i asking to much or am i being reasonable?

 

olymaster

New Member

May 15, 2005

179

1

0

columbus ga

Jun 7, 2005

#2

• Jun 7, 2005

• #2

www.cobraengines.com
i got mine thier comes turnkey ready to go and its top of the line very good work, strong couldnt be happier!355hp 302
all elbrock blueprinted forged cromed s nice

 

trents99

Founding Member

Jun 28, 2002

438

0

0

Hampton, GA

Jun 8, 2005

#3

• Jun 8, 2005

• #3

Only one I know of is an FRPP that goes for around $3100-$3200. It's not gonna put the power down you want though. From what I have read they usually hit about 260rwhp. They don't come with intakes or valve covers either IIRC and you have to swap the front accesories and oil pan.

On the other hand if you could come up with a little more Keith Craft has a 306 complete with heads and intake that advertises 375hp (flywheel rated I'm sure) for about $4250. Based on loss through a 5-speed that would get you the power you want pretty much.

 

markc522

New Member

Apr 4, 2005

23

0

0

dfw

Jun 10, 2005

#4

• Jun 10, 2005

• #4

im still looking for that killer deal.
thanks for the ideas

 

accidentprone86

New Member

Apr 1, 2005

189

0

0

Westminster Colorado

Jun 10, 2005

#5

• Jun 10, 2005

• #5

Are forged internels really nessisery? cuz none of those high horsepower engiens have all forged internals.

 

B

BaXTeR3221

Member

Jan 12, 2004

917

0

16

Orange County, NY

Jun 10, 2005

#6

• Jun 10, 2005

• #6

If your looking for a killer deal, there are always motors on corral.net , a lot of which have never even been run.

 

markc522

New Member

Apr 4, 2005

23

0

0

dfw

Jun 10, 2005

#7

• Jun 10, 2005

• #7

Thanks Guys