Degreeing my cam ?

Im takin the motor this week to be taken apart, clearances checked, balanced, and having the cam, and heads installed (i dont know enough to degree the cam myself, and my torque wrench is MIA) What im trying to figure out is what degree should i request the cam to be set at... is this a manufacturers recomendation, or does it depend on motor setup.....? any help would be greatly appreciated.
 
When you degree the cam you are just verifying the valve events compared to the advertised specs and then making slight adjustments accordingly.

Most of the time people install the cam straight up. You can go up to 4 degrees advanced / retarded. I don't remember correctly but if you advance you get a little more HP and lose some Torque and then if you retard you get some more torque and lose some HP...

To degree the cam you need a degree wheel, dial indicator with magnetic base and your cam spec card. I think Comp cams has a good write up on their site about it also.
 
Thanks for the info... im takin it to the machine shop as i said, and they had told me to know where i want the cam (advanced/retarded/straight) when i bring it up there, so i thought id just check to make sure.. everyone else ive asked said to just install it straight up as well.
 
Rick 91GT said:
What's the combo, what cam?



-Block Bored and honed to 306
-Trickflow 10:1 forged pistons
(all being balanced this week)
-Trickflow Track Heat Heads
-RPM Air Gap intake
-Holley 600cfm double pumper
-Trickflow 6.700 pushrods
-Trickflow stage II cam ( duration 224*/232* lift .542"/.563")
-FMS lifters
-BBK Shorties
-H pipe
-Stock gears for now (308)
-Rebuilt T-5 with hanlon block & ring kit
-Super King Cobra Clutch
 
Retarding the cam moves the powerband lower.
Advancing the cam moves the powerband higher.

It just depends on where you want your power as opposed to where the cam makes it's power normally. For instance, if your cam makes peak power at 5,500 rpm degreed straightup, and you want your power a little higher, then advance it some.