• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Did I do any long term damage?!?!?

  • Thread starter Thread starter 89LXNotchPI
  • Start date Start date Aug 19, 2005
8

89LXNotchPI

New Member
May 28, 2005
21
0
0
Washington
Aug 19, 2005
#1
  • Aug 19, 2005
  • #1
Just found out that my stang has been running on 7 cylinders for about the last 3 months, maybe longer. Just wondering if I will suffer any long term consequinces from this or will it run like it did before the fouled wire/plug/dist. cap? PLease help put my mind at ease. Thx a bunch!
 
J

Jeff7477

Founding Member
Jul 2, 2001
176
0
0
Lincoln, Nebraska USA
Aug 19, 2005
#2
  • Aug 19, 2005
  • #2
I don't see any problem with it. Its still getting the same amount of lubrication....it just wasn't firing.
 
T

TheUser

Active Member
Jul 25, 2003
1,859
1
36
Springfield, MO
Aug 19, 2005
#3
  • Aug 19, 2005
  • #3
Jeff7477 said:
I don't see any problem with it. Its still getting the same amount of lubrication....it just wasn't firing.
Click to expand...
well the spark plug wasn't firing, but the injectors were prob. squirting a lot of fuel in that cyclinder which wasn't getting burnt off. Not sure what that does for rings, but i'm sure some of it went through the exhaust and, if you have catalyctic convertors on the car, maybe wasn't the best for those - depending on the amount of miles put on the car w/ that condition. I'd also hazzard a guess that a good portion of that raw fuel made it's way past the rings into the crankcase and polluted your oil. I'd change the oil ASAP if you haven't.

I suppose you could do a compression check or leak-down test to see if it damaged rings...I really don't know how much damage this could have done, just trying to do some semi-educated guessing.

I would have thought you would notice a cyclinder not firing...didn't the car run like crap? Do you have any check engine codes?
 
8

89LXNotchPI

New Member
May 28, 2005
21
0
0
Washington
Aug 19, 2005
#4
  • Aug 19, 2005
  • #4
Negligence on my part...no codes however. The car was running poorly, but once it was warm it seemed to run fine. 7 of 8 cylinders didn't make that much difference. But I should've noticed sooner, all I can do now is damage control.
 
8

89LXNotchPI

New Member
May 28, 2005
21
0
0
Washington
Aug 20, 2005
#5
  • Aug 20, 2005
  • #5
also, the exhaust is cat-less, so that solves that problem, should I clean the O2 on that side and reset the comp?
 
T

TheUser

Active Member
Jul 25, 2003
1,859
1
36
Springfield, MO
Aug 20, 2005
#6
  • Aug 20, 2005
  • #6
one time I had a mouse that kept biting through one my my injector wires on my v8 Jeep, so I effectively had 7 cyclinders and it ran like crap. Definately probably wouldn't hurt to clean the o2 up and be sure and reset the computer if you do - ask you suggested. I'm not sure of the technical method to cleaning them - if there even is one - but I've pulled them and burnt the junk off w/ a propane torch for about 5 minutes letting it glowing red repeatedly. Remember to put anti-sieze back on the threads before reinstalling, but be careful to not get it on the actual sensor part...that's hard to do for me.

Good luck.
 

DMAN302

My mom says thanks for the pearl necklace.
Nov 8, 2003
2,120
2
59
windsor, Canada
Aug 20, 2005
#7
  • Aug 20, 2005
  • #7
Second on the oil change!!
 
8

89LXNotchPI

New Member
May 28, 2005
21
0
0
Washington
Aug 20, 2005
#8
  • Aug 20, 2005
  • #8
Got to work this morning, found that a bad wire had caused my plug to foul. new wires, cleaned the cap, new plug, changed the oil, cleaned the O2, car feels great! A happy ending...finally. Thanks for the input.
 

CManT1914

New Member
Feb 5, 2004
3,172
2
0
Killeen, Texas
Aug 20, 2005
#9
  • Aug 20, 2005
  • #9
Glad to hear you got it worked out. If you want some peace of mind, do a compression check, and see how that 1 cylinder stacks up against the others. If you're getting too much gas in there, then it could have been washing the cylinder walls. You might have messed up your rings, although it's not too likely.
 
You must log in or register to reply here.

Similar threads

L
Engine Why won't the motor start if I have spark and fuel
  • LeviAnderson
  • Nov 20, 2025
  • Fox 5.0 Mustang Tech
Replies
3
Views
560
Fox 5.0 Mustang Tech Nov 20, 2025
AeroCoupe
B
Where to go from here on my build…
  • B0udreaux
  • Jul 14, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
8
Views
457
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Jul 18, 2026
AeroCoupe
D
Engine 85 GT Backfires through Carb
  • DienstXIV
  • Oct 3, 2025
  • Fox 5.0 Mustang Tech
Replies
19
Views
995
Fox 5.0 Mustang Tech Oct 7, 2025
85GTStangGuy
Engine Random Misfire at idle.
  • Gulftown980x
  • Jul 29, 2026
  • SN95 4.6L Mustang Tech
Replies
11
Views
610
SN95 4.6L Mustang Tech Jul 31, 2026
squeak93
D
Foxbody Misfire 5.0 Swap
  • DPORTER0729
  • May 2, 2025
  • Fox 5.0 Mustang Tech
Replies
7
Views
773
Fox 5.0 Mustang Tech Jul 13, 2025
90sickfox
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?