My wiring harness for my o2s got ripped off a LONG time ago and I was just running without them. Now that I have a forced induction car I need them to get it tuned. So I bought a new wiring harness and 2 new o2 sensors and I put them in. Now it seems that the driver side wiring wants to drag the ground while if I pull the wiring harness after they are connected to the o2s the passenger side is too short to allow me to get the slack out of the drivers side. How does the wiring harness route? Does anyone have any pics or know where I can get some info on how to route it? I have long tube headers so it is hard to use plastic ties <-----best invention EVER....... to tie them up because they will lay against the header!!!