I seen a picture of someones car on one of the mustang Forums where a guys Fender was screwed and he couldnt figure out why, someone told him to look under the car cause someone put a jack or lift in the wrong place. Anyway, my fender stuck out a bit on my car if you ran your hand across the door you would hit the Fender, so I looked underneath and sure enough my floor was pushed up, so I got the sledge out and beat it down. I loosened all the bolts on the fender pushed in on it and tightened everthing back up and it was even with the door, but now my gap is gone and when I go to open the door it rubs on the fender. I tried putting cardboard in the gap before tightening everything but its still the same, any ideas on what I am missing to adjust some gap between the door and fender, BTW its only rubbing right inside where the bodyside moulding is.