• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

Dumps before mufflers

  • Thread starter Thread starter jas142
  • Start date Start date Dec 9, 2003
J

jas142

Founding Member
Feb 11, 2002
1,358
0
0
Dec 9, 2003
#1
  • Dec 9, 2003
  • #1
I'm still trying to figuire out the best exhaust setup for my needs

How would the exhaust sound on a stock 2v 4.6 with dumps (cutouts) right before the mufflers? Instead of using cutouts before the cats, i'd do them before the mufflers so I could still hopefully have some throttle response and low end torque... but some loud exhaust sounds too. How would it sound?
 

stangman

15 Year Member
Jul 10, 2003
2,690
10
69
in a 3 bed, 2 bath
Dec 9, 2003
#2
  • Dec 9, 2003
  • #2
if it's your daily driver i wouldn't do it. i had a prochamber & mac flowpaths, on my old car, with no dumps - the exhaust just exited staight out the muffler & it was way too loud. it sounded cool & all, like a friggin nascar, you could hear me for like 20 blocks . i had to keep asprin in the car for a 15 min drive to work, & forget it if you actually want to talk to someone in the car, let alone on the cell phone. but if you want loud & it doesn't bother you, that's the way to go i ended up adding a catback real quick, & it made it perfect for me. if i was beside you, you would know it, but it wasn't obnoxious loud. but if i wanted to make some noise, i certainly could
 

MustangMuscleV8

New Member
Dec 2, 2003
173
0
0
Stangnet.com
Dec 9, 2003
#3
  • Dec 9, 2003
  • #3
you are going to pay more, but you can get electric cutouts, which allow you to open and close them from inside the car. they *are* more $$$ though.
 
T

TARZAN

New Member
Apr 25, 2003
446
0
0
Philly MS
Dec 10, 2003
#4
  • Dec 10, 2003
  • #4
I'd say just not to do it!!!!

It is going to souns horrible, and I know some ppl. who just went w/ straight exhaust after the cats, and the cars didn't seem to run very well at all.

Either just wait, save up, and do the exhaust right.........or don't do it at all, b/c you'll regret it.

-Will
 
F

Fixxxer_14

New Member
Dec 7, 2003
3
0
0
Minot, ND
Dec 10, 2003
#5
  • Dec 10, 2003
  • #5
How about a cutout (like a race-ready) before the mufflers, so you could always cap it off for trips and stuff?
 
J

jimfitzgerald

New Member
Apr 11, 2001
6,672
0
0
Dec 10, 2003
#6
  • Dec 10, 2003
  • #6
I have dumps after the mufflers and that's freaking loud enough. I have Kooks longtube headers, Kooks 3 inch O/R X-pipe, and dumped Dynomax Race Magnum mufflers. I like the sound, but it's loud. I definitely would not want it any louder.
 

FastRedPonyCar

Founding Member
Apr 7, 2002
1,678
4
39
I pee sitting down...or do I?
Dec 10, 2003
#7
  • Dec 10, 2003
  • #7
i had the manual cutouts on my car with the bassani o/r x pipe and 2 chambers. it's very loud with the cutouts closed and sounds like a freakin nascar with them open.

Eventually the welds on the cutout flaps broke and I got them taken off. I'm planning on getting the exhaust redone when I do the headswap and LT install and I'm gonna put a set of high quality electric cutouts on.
 
9

99LEGT

New Member
Dec 8, 2003
73
0
0
Philadelphia
Dec 10, 2003
#8
  • Dec 10, 2003
  • #8
Cutouts

Yeaf Bro I put electronic dumps on my 93 after the h-pipe and the car never ran right, no Back pressure means no Horsepower!
 

MustangMuscleV8

New Member
Dec 2, 2003
173
0
0
Stangnet.com
Dec 10, 2003
#9
  • Dec 10, 2003
  • #9
really you had trouble?
 

FastRedPonyCar

Founding Member
Apr 7, 2002
1,678
4
39
I pee sitting down...or do I?
Dec 10, 2003
#10
  • Dec 10, 2003
  • #10
most guys lose low end but gain high end. I did.
 

Dominus_Servi

New Member
Apr 28, 2003
240
0
0
San Diego, CA
Dec 14, 2003
#11
  • Dec 14, 2003
  • #11
Anyone have dyno numbers for the cutouts? If so, where were yours installed...before or after cats?
 
J

jas142

Founding Member
Feb 11, 2002
1,358
0
0
Dec 14, 2003
#12
  • Dec 14, 2003
  • #12
Hmm.. So will you lose any backpressure if they're installed AFTER the mufflers? I'm definately getting the UPR X pipe, but I don't know whether to get the cutouts after mufflers or just get some 40 series flowmasters. Which would be louder/meaner sounding
 

Yellow01GT

Founding Member
Dec 14, 2001
1,127
0
36
Jefferson City, MO
Dec 14, 2003
#13
  • Dec 14, 2003
  • #13
There's no point in putting cut-outs after the mufflers.
 

Dominus_Servi

New Member
Apr 28, 2003
240
0
0
San Diego, CA
Dec 18, 2003
#14
  • Dec 18, 2003
  • #14
so how about before or after the cats...sound and/or performance difference?
 

19mustangGT97

New Member
Feb 12, 2003
122
0
0
Foster City, CA
Dec 18, 2003
#15
  • Dec 18, 2003
  • #15
I have my cutouts right before my mufflers on the stock H pipe and everyone thinks that I have more exhuast work done becuase its loud but everyone thinks it sounds good too... I will post a sound clip so you guys can hear it and my car has been working perfectly fine since I put them in so don't listen to the people that say it won't run right. You do lose low end torque due to the loss of backpressure but you gain up high. I went from a 15.5 with a 2.28 60' to a 15.0 2.3x 60' with the only new mod being cutouts but I also drove a lot better. I think it sounds good and now I'm going to put an o/r x on so it will be crazy loud!
 
You must log in or register to reply here.

Similar threads

K
Engine 2000 Mustang GT - Fuel issue post-blown spark plug repair
  • kenster1092
  • Feb 26, 2026
  • SN95 4.6L Mustang Tech
Replies
4
Views
288
SN95 4.6L Mustang Tech Mar 10, 2026
kenster1092
K
M
Engine Unexplainable Exhaust Pop and Gurgle
  • Mrnissen122
  • Feb 14, 2026
  • Fox 5.0 Mustang Tech
Replies
12
Views
468
Fox 5.0 Mustang Tech Feb 18, 2026
Noobz347
G
Quiet my 2015 GT on the cheap
  • gsrblack
  • Feb 12, 2025
  • 2015 - 2023 (S550) Mustang -General/Talk
Replies
6
Views
727
2015 - 2023 (S550) Mustang -General/Talk Apr 16, 2025
gkomo
Tuners come on inside
  • squeak93
  • Feb 13, 2026
  • SVT Tech Forum
Replies
1
Views
216
SVT Tech Forum Feb 20, 2026
squeak93
J
2004 Mustang 3.8L V6 vibrations above 65 MPH and differential leaks
  • joeybuddy96
  • Mar 16, 2026
  • SN95 V6 Mustang Tech
Replies
13
Views
389
SN95 V6 Mustang Tech Monday at 2:45 PM
joeybuddy96
J
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?