Dyno Tune

FordGuy88

New Member
Nov 15, 2004
241
0
0
Park Ridge, IL
How much can you get a 5.0 dyno tuned for? My friends car will be a NA 331 H/C/I set up. We were wondering if it is really needed too? I know it is on a boosted car, but wasnt sure on a NA car. Will I gain any power, or what really is the advantage of it? Thanks alot.
 
I dont know anyone who had their car tuned with just heads and cam. Usually they have it tuned when going with boost. I know a few guys that are stil tuning their stroker motors off the factory ECU and seem to run quite well.
 
I'm just bolt ons, but my next motor mod is gonna be a Tweecer just so I know that every time I buy another part to add to my combo, I can spend another $100 and ensure I get the absolute max out of it.
 
anytime u stroke a motor to get more cubic inches u need to get a custom chip burned. The stock computer still thinks it is a 302, not a 331. The chip will dial in the a/f ratio to prevent u from running too rich or too lean. Too rich will wash out the rings, glazing the cylinder walls and preventing the rings from seating. Too lean will damage the engine burning up the pistons.
 
I went with a mild 351 using a stock A9P and was
mostly concerned with a safe tune than max power
out of it - I do lots of road driving with a heavy car.

I talked to the dyno operator a few days before and
he advised putting on an adjustable regulator and
turning it down to 33 psi.

I got one and made it 34 psi, and it seemed to accelerate
a lot crisper than before.

On the dyno, the air/fuel ratio was just right.

The operator said a chip wasn't necessary
(I had been concerned about too much part throttle
advance because of the load table thing for a 302 vs a 351)
and there's no detonation as is.

We played with the timing a little bit, but advancing it
from the stock 10 to 14 didn't do a single thing, so I
put it back down to 10 so I can run mid grade.

Only took about 1/2 hour and cost me $55.00.