Hi everyone! This is my first post, as I have recently purchased an 87 gt t-top car for the reasonable price of $350! I have taken care of some of the mechanical issues, and now am starting work on the go fast goodies. So far in my garage, I have accumulated an explorer gt40 intake, stainless shorty headers, an E303 cam, and a few days ago got a set of Edelbrock performer aluminum heads with 1.6 ratio roller rockers (used for a crazy price) with less than 1000 miles on them from a friend of mine. He had them on his 5.0 powered 68 Bronco, but switched to gt40 X heads and installed an aftermarket cam. My question is..I've been told that stock length push rods will not work, as I need shorter push rods. Can anyone confirm this, or if youre running the same heads, what length push rods are you using? I was told that I will get "coil bind" in the valve springs using the stock length push rods. Also while I'm at it, what size injectors will I need to go to...24#..30#? Thanks in advance for any help given. I've owned a few 4.6 cars, but this is my first 5.0