Electrical Problem With 85gt

DADDY'S85GT

New Member
Jan 1, 2005
1
0
0
PLEASE ANYONE ,,,, THOUGHT IT WAS THE SILINOID CAUSE IT WAS FRIED BUT BURNED NEW ONE UP TOO ,,,, ANYWAY WHEN I TURN THE KEY IT TRIES TO START(AFTER NEW SILINOID IS IN) BUT IT KEEPS ON TRYING TO TURN OVER AND START ON ITS OWN WITH THE ''KEY OUT OF IGNITION'' AND BURNS UP SILINOID AGAIN.............JAY.................. :stupid:
 
Jay, welcome to the board (not chronologically, but tech-post wise).

If you have a car that wont quite crank over, and the solenoid chatters (tick tick tick, or clack clack clack), it can latch (fuse) the contacts in the solenoid.
Only solution I know of is to get a new one and make sure the primary electrical is up to par. Then dont hold the key in 'crank' for more than two seconds if the motor wont actually turn over.

Good luck.
 
It seems like the solenoid is welding the contacts together. You may be able to unstick the contacts, but you will need to completely remove the solenoid. Place it in your palm, stud side up: you may want to put a shop rag between your palm and the studs to protect your hand. Now smack the bottom of the solenoid hard against the pavement or something really solid. If they are not completely welded, it will unstick them.

Make sure that your battery is up to full charge, a low battery will cause the starter to pull more current. Charge the battery or use some jumper cables connected to a car with the engine running about 1500 RPM. If you use the jumper cables, run them connected for 5 minutes to help charge your battery.

Once you have eliminated the battery as being the problem, the starter is the only thing left.
 
Best idea is to go through the start circuit with a meter, and see what you find.

I would start by checking ignition switch alignment with the key activator rod, etc.

If the switch does not move back to the correct place when the key does, it can keep engaging the solenoid, and will burn the contacts together.