M mikem21 New Member Apr 17, 2007 2 0 0 Oct 10, 2007 #1 Oct 10, 2007 #1 I finally got around to tearing down a .030 motor that I bought. I wanted check it before install. Its e7ae block with a e7ae crank but it has d10e connecting rods(early 70's) just wondering if it is ok to run like this. thanks
I finally got around to tearing down a .030 motor that I bought. I wanted check it before install. Its e7ae block with a e7ae crank but it has d10e connecting rods(early 70's) just wondering if it is ok to run like this. thanks
5spd GT "the 5.0 owns all" Founding Member Aug 7, 2002 9,516 6 99 Arkansas Oct 10, 2007 #2 Oct 10, 2007 #2 Do you have any extra numbers that go after the e7ae? Those are pretty generic numbers. If it is a 3.00" stroke, 4.030" piston, and a 5.090" rod, it should be no problem.
Do you have any extra numbers that go after the e7ae? Those are pretty generic numbers. If it is a 3.00" stroke, 4.030" piston, and a 5.090" rod, it should be no problem.