Export brace and EFI

This is what I made:
v1.0

v1.5 - This one was too close to the rear corner of the intake and the MC bar wouldn't clear the distributor.

v2.0 - Curved MC bar and moved the rear mounting points of the export brace outward.


Obviously it is not adjustable. It cost about $10.00 for enough 1" OD DOM tubing to make two.

Pardon the sanding dust

Nice looking setup Rustang. Looks like a very nice job.
Gives use all ideas

-Stephen

WOW - that is VERY impressive, thanks for sharing the photo's! Wish I had the knowledge and equipment to weld. Very good job there!