Finally got everything squared away with my MAF problems. I did have to change the electronics with the C and L system. The sensor was bad. I put a BBK FPR on. With the 24 pound injectors I am running about 34 pounds of fuel pressure. Everything is finally up and running great.
I just also finished installing a Motorvation pulley set, minus the Alternator pulley. I was going to go with a BBK set, but the guy at Summit talked me into this one.
My next project, hopefully next week, is to replace my clutch with a King Cobra clutch and also replace the quadrant. After that I will probably buy a MSD 6A and coil. If anyone has any other recomendations for that I would appreciate it.
I just also finished installing a Motorvation pulley set, minus the Alternator pulley. I was going to go with a BBK set, but the guy at Summit talked me into this one.
My next project, hopefully next week, is to replace my clutch with a King Cobra clutch and also replace the quadrant. After that I will probably buy a MSD 6A and coil. If anyone has any other recomendations for that I would appreciate it.