ah man Slimmer strikes again! hey on the lower intake u may wanna run a softpad grinder over that slipp up kut on the left runner (bottom pic). Depending on how deep it is...its nice to start a gasket on a flat surface ;o) looks good...though i would polish the insides more if time provided...
Yeah I know, the skimmer is hardly on there, it actually is just a mark in the dirt thats on there, I can run my fingernail across it and not feel it... I didnt tighten it down enough and it slipped in the vice...
The bottom one was the carbide bit, the top one was the chuck from the die grinder as I reached up to catch it...
Yeah I know, the skimmer is hardly on there, it actually is just a mark in the dirt thats on there, I can run my fingernail across it and not feel it... I didnt tighten it down enough and it slipped in the vice...
The bottom one was the carbide bit, the top one was the chuck from the die grinder as I reached up to catch it...