I am selling this due to a H/C/I swap to a solid roller setup. This was in my '92 full interior, pc/ac, 5 speed street car and saw between 2-3000 miles and 20 1/4 runs. It drove well and made peak horsepower at ~5900 rpms. Made 450rwhp on a mustang dyno and 467rwhp on a dynojet.
Setup it was run on:
PMAS 95mm velocity
Anderson 4" powerpipe
Accufab 90mm TB
Victor Junior carb style intake converted to EFI and ported by XSR heads
Procomp 210 heads ported by XSR heads
Mac 1 3/'4 LT
Mac 3" Prochamber
Dynomax 3" Ultaflow dumps
3.73 gears
I easily ran 11.7-11.9 at 122-124mph with 1.8x-2.00 60's That is leaving out of the hole at idle with minimal spin so with a better driver and launch this would have more mph and should easily break 10s.
Designed for 408+ with ~10.5:1 compression.
Billet core
.623/609
236/254
112
I can provide a photo of the original cam card to anyone who is interested.
$220 shipped in the lower 48
Setup it was run on:
PMAS 95mm velocity
Anderson 4" powerpipe
Accufab 90mm TB
Victor Junior carb style intake converted to EFI and ported by XSR heads
Procomp 210 heads ported by XSR heads
Mac 1 3/'4 LT
Mac 3" Prochamber
Dynomax 3" Ultaflow dumps
3.73 gears
I easily ran 11.7-11.9 at 122-124mph with 1.8x-2.00 60's That is leaving out of the hole at idle with minimal spin so with a better driver and launch this would have more mph and should easily break 10s.
Designed for 408+ with ~10.5:1 compression.
Billet core
.623/609
236/254
112
I can provide a photo of the original cam card to anyone who is interested.
$220 shipped in the lower 48