- Sep 2, 2004
- 466
- 0
- 0
$450.00 plus shipping.
These are MPH's custom Kenne Bell grind they had made by CompCams, for use in 2-valve PI heads. They come alive at 3,000 RPM and pull relentlessly beyond 7,000 RPM with no sign of letting up. Perfect for the low RPM torque of twin-screws. A KB 2.6 will easily make over 600 RWHP with these cam's and stock PI castings. A KB 2.1 would even make aorund 550 at the wheels with the same combo. They'll remain installed in the heads until a buyer comes along. The engine is out of the car so I can pull the cam's out at any time.
http://www.dfwstangs.net/classifieds/data/11/large/motorresized.JPG
These are MPH's custom Kenne Bell grind they had made by CompCams, for use in 2-valve PI heads. They come alive at 3,000 RPM and pull relentlessly beyond 7,000 RPM with no sign of letting up. Perfect for the low RPM torque of twin-screws. A KB 2.6 will easily make over 600 RWHP with these cam's and stock PI castings. A KB 2.1 would even make aorund 550 at the wheels with the same combo. They'll remain installed in the heads until a buyer comes along. The engine is out of the car so I can pull the cam's out at any time.
http://www.dfwstangs.net/classifieds/data/11/large/motorresized.JPG