Fuel Leak from Rails

Lefty44278

New Member

Jun 19, 2003

284

0

0

Detroit, Michigan

Jul 18, 2005

#1

• Jul 18, 2005

• #1

I recently upgraded my fuel injectors to 42#'s. While I was running the motor for 15 minutes, fuel started spraying from the rails. The fuel rail seperated from the injectors (I have the areomotive fuel rails.) Could the fuel pressure be to high? It is set around 38 w/ a supercharger. Or could it be the FMU? I heard that the unit may have to be calirbrated. Could there be any other cause? Thank you for your help.

 

jrichker

StangNet's favorite TOOL

In Remembrance. Thank you for your contributions

Mar 10, 2000

27,512

2,813

234

Dublin GA

Jul 18, 2005

#2

• Jul 18, 2005

• #2

Is there a bar that connects to the rails and then bolts to the lower manifold? If not fab one, if so, you may need to make a shorter one.

 

Lefty44278

New Member

Jun 19, 2003

284

0

0

Detroit, Michigan

Jul 18, 2005

#3

• Jul 18, 2005

• #3

There are 4 eye holes that bolt to the lower intake, but no bar

 

bullitstang1313

Member

Jan 21, 2003

713

0

16

Indianapolis / Columbus, Indiana

Jul 18, 2005

#4

• Jul 18, 2005

• #4

When you bought the 42# injectors were they new or used? If they were used, did you put new o-rings on them? Just a thought, but I would also do what jrichker already said.

 

Lefty44278

New Member

Jun 19, 2003

284

0

0

Detroit, Michigan

Jul 18, 2005

#5

• Jul 18, 2005

• #5

No, the injectors are new. Do you think I should get thicker o-rings if they are available, and if so where do I get them.

 

jrichker

StangNet's favorite TOOL

In Remembrance. Thank you for your contributions

Mar 10, 2000

27,512

2,813

234

Dublin GA

Jul 18, 2005

#6

• Jul 18, 2005

• #6

Fuel injector seal kits with 2 O rings and a pintle cap (Borg-Warner P/N 274081) are available at Pep Boys auto parts. Cost is about $2.74 per kit.. The following are listed at the Borg-Warner site ( http://www.borg-warner.com ) as being resellers of Borg-Warner parts:

http://www.partsplus.com/ or http://www.autovalue.com/ or http://www.pepboys.com/ or http://www.federatedautoparts.com/

Most of the links above have store locators for find a store in your area.

Use motor oil on the O rings when you re-assemble them & everything will slide into place. The gasoline will wash away any excess oil that gets in the wrong places and it will burn up in the combustion chamber.