Fuel line questions

shootme5150

New Member
Jul 12, 2003
84
0
0
Denver
I'm pulling my engine and it looks like the last thing holding on are the fuel lines. Two questions:

1) Do I have to release the fuel pressure? If so, how would I go about doing that? My manual only talks of running the car with the inertia switch disconnected, but I'm not exactly in position to start it. I believe I found the schrader valve, but I have no idea what to do with it. I thought there would be a little 'pin' inside of it like a tire, but I can't feel anything.

2) How the %&$* do I get the fuel lines off? I've got a tool that looks kinda like this, but I can't seem to push or pull the connector. Will it not move if the lines are pressurized? Is this thing really THAT difficult to use (should I grab the little colored ones)?

Any help would be much appreciated.
TIA
 
Yes you should release the pressure in the system. The schraeder valve is on the fuel rail and you should be able to see the pin (like the tire valves). Since you can't start the car, you'll get some gas on you. Another place to release pressue would be disconnecting the fuel filter. Again you'll get gas all over but usually it's not too much (I know, I've accidently done this on a pressurized system before).

The tool you have will work so long as the end sizes are appropriate for the fuel line connectors and fit inside the larger connection, though I'm used to having several different sizes, each in an individual circular tool. I have found that inserting the tool into the connection, holding the line that the tool is on, then pushing the two lines toward each other before pulling apart works best for me.

Good luck,