Fuel starved?

tommy_1812

New Member
Dec 21, 2005
41
0
0
Kerrville, TX
How do I know if the car is fuel starved? I've got a few mods (BBK air intake, BBK headers, intake spacer, B303 cam, bored .030 or .040 over, under drive pulleys, electric fan, blaster coil, high performance distributor and ford racing wires. It's mainly bolt ons, and I plan on adding a 76 mm C&L meter, BBK SSI intake kit (upper and lower, high flow fuel rails, and 70 mm throttle body).

Should I upgrade to 24 or 30 LB injectors before I do this setup? I have a stock fuel pump.
 
Running bigger injectors with your setup would garuntee that you have plenty of fuel, and that starvation wouldnt be an issue. Your running a setup similar to mine.. and i stepped up to #24s, a 70mm ProM mass air with a 190lph fuel pump, and with a tune.... i have no problems. Just remember that if and when you do run an aftermarket MAF and injectors... you need to recalibrate the ECU for everything to work properly. :)

Ant
 
You car should in no way, shape, or form be starved for fuel due to power demands of your mods. There is no reason to be upgrading either the injectors OR the fuel pump.

If you feel that your car may be running "lean" you can always hook up a wideband o2 to it and know for sure where your air/fuel ratios stand.

Or, you could do the "round-about" test and look at the spark plugs for tell-tell signs of leaning out.

All in All, the stock fuel system (injectors, pump, etc) are good for 250+ RWHP and you MIGHT be making 200-220. If you know you are having fuel issues it may be due to a failing fuel pump, too much timing, dirty fuel filter, incorrect fuel pressure, etc... but not because of the size of your injectors.