Mach428 New Member Dec 7, 2003 321 0 0 Dec 17, 2003 #1 Dec 17, 2003 #1 I was just wondering if any of you had a G-Tech, if so I have a couple of questions. Is it acurate? Is it hard to install? How much was it? Where did you buy it?
I was just wondering if any of you had a G-Tech, if so I have a couple of questions. Is it acurate? Is it hard to install? How much was it? Where did you buy it?
FreeGT New Member Dec 9, 2003 81 0 0 St. Louis Dec 17, 2003 #2 Dec 17, 2003 #2 I got mine for $249 from god knows where. The accuracy depends on how you set it up. 1. Make sure the RPMs are consisant during calibration, and get your car weighed w/ driver. (I use a local semi truck scale) 2.always use flat road 3.mount in center of windshield 4.don't excessivly spin the wheels at launch. get that right, and my runs were within 1-2 tenths of my runs at the track. It is not for extreme accuracy, but can give your a real good idea. For some reason it doesn't work with old ford FE engines, like my 69 428cj mach1...................
I got mine for $249 from god knows where. The accuracy depends on how you set it up. 1. Make sure the RPMs are consisant during calibration, and get your car weighed w/ driver. (I use a local semi truck scale) 2.always use flat road 3.mount in center of windshield 4.don't excessivly spin the wheels at launch. get that right, and my runs were within 1-2 tenths of my runs at the track. It is not for extreme accuracy, but can give your a real good idea. For some reason it doesn't work with old ford FE engines, like my 69 428cj mach1...................