• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SVT Tech Forum

Got half my engine apart, Question about the IMRC!!!

  • Thread starter Thread starter tmoneyballin
  • Start date Start date Jan 21, 2007

tmoneyballin

New Member
Aug 16, 2006
113
0
0
Suwanee, GA
Jan 21, 2007
#1
  • Jan 21, 2007
  • #1
I posted in recent thread that my check engine light was turning on because of my IMRC, the advice I got was to clean it and we did both of them, but what I am wondering is does the imrc box itself necessarily have to be replaced to fix the problem(the small box connected to the lower intake)? I know a bad 02 sensor can throw the code as well so I can't rule that out at this time either. But I am wondering if we just cleaned everything and put the engine back together if it will solve the problem, or do I wait and just purchase a new module and install it the middle of the week? In other words does cleaning commonly solve the problem?

Any advice and or scenarios is GREATLY appreciated, I assure you my upper and lower intake are sitting on the garage floor!
 

wythors

Get off my lawn!!!
Founding Member
May 17, 2000
2,277
35
69
C Addle
Jan 21, 2007
#2
  • Jan 21, 2007
  • #2
Yes, cleaning should take care of it. Unless the box is not functioning, there's no need to replace it.
 

TheCrazy1

New Member
Dec 8, 2003
70
0
0
Jan 25, 2007
#3
  • Jan 25, 2007
  • #3
I've heard that cleaning usually takes care of the problem, also since you have it all apart, it's a good idea to replace the actuator. It would really suck to put it all back together only to find that it's still not working right. I don't know if there's any way to test the functioning of the box; most likely there is, as with most of the electronic parts. Don't quote me on this, but I don't think the actuator unit is terribly expensive, like in the 100 dollar range.
 

tmoneyballin

New Member
Aug 16, 2006
113
0
0
Suwanee, GA
Jan 25, 2007
#4
  • Jan 25, 2007
  • #4
Thanks for the advice guys,

I actually went ahead and drove an extra 2 hours to a remote ford dealership and purchase the actuator ($300) on Saturday. We installed it to the lower intake manifold and put the car back together Monday - only to hear a bad fuel injector. Replaced the fuel injector last night and cranked - heard a vaccum leak - replaced the guilty lines - car runs STOUT now! I wouldn't know how it "drives" because the drivetrain is all in shambles - hence the post about putting 4:30 geas in - once I get the gear installed, hook up the new aluminum driveshaft, put the drag suspension on this baby will be BUMPIN up and down when I bang gears! Any advice on my gear post is appreciated -

Moral of the story on this project, I think the actuator WAS messed up because the check engine light previously came on and off randomly(hard acceleration seemed to trigger it...) and in the last couple months stayed on permanently which could imply the IMRC'S were stuck open or closed until it would be fixed. They weren't that dirty so I figured might as well replace the obvious solution(**** the car has 113k on it anyways, an electronic part is bound to go bad sooner or later...) before putting the car back together with the same problem.
 
You must log in or register to reply here.

Similar threads

J
'96 Cobra: A/C gets weak and engine misfires under load when warm
  • jruhnke
  • Oct 22, 2025
  • SVT Tech Forum
Replies
2
Views
292
SVT Tech Forum Nov 20, 2025
nickyb
M
01 mustang 3.8 fuel pressure issue
  • Mhaley2006
  • May 29, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
0
Views
87
1996 - 2004 SN95 Mustang -General/Talk- May 29, 2026
Mhaley2006
M
J
Emission problems
  • jls.zmmr
  • Feb 5, 2026
  • 1994 - 1995 Specific Tech
Replies
2
Views
221
1994 - 1995 Specific Tech Feb 7, 2026
AeroCoupe
L
95 gt engine vibration
  • lenzgt
  • May 11, 2026
  • 1994 - 1995 Specific Tech
Replies
6
Views
161
1994 - 1995 Specific Tech May 26, 2026
lenzgt
L
B
Paint in engine bay questions
  • B0udreaux
  • Feb 26, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
8
Views
259
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Feb 27, 2026
AeroCoupe
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SVT Tech Forum
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?