Granada tie rod ends

[brianj5600]

A friend of mine with a 66 put on aftermarket brakes and is giving me his Granada brakes. I have a 67 will I need different tie rod ends? If so are they readily available? And what application? Where to buy? Thanks

 

[2bav8]

Granada outer tie rods are readily available at just about any parts store.
They run around $15 a piece. I bought mine at Autozone.

 

[chris txstang]

Try these, they are much cheaper:

http://www.mustangsteve.com/tierodbushings.html

 

[brianj5600]

I'm getting the tie rods used on his car, a 66, will they bolt right up to my 67?

 

[mustangfb66]

If you friend has V8 power steering on his '66 then I think you will need different tierod ends. Other wise I think you are good to go. Basicaly, '65-66 stangs with V8s and power steering had smaller diameter tie rods. Someone correct me if I'm wrong....

 

[D.Hearne]

The 67's had many of the same frontend parts as the 65-66's did, even though the suspension was widened for big blocks. Steering gear was the same unit for the early 67's. The tie rod ends should fit.

 

[stangman67]

i just did this and the mustang tie rod ends where to small, so you can use 1970 mustang tierods since the granada ends are for rack and pinion steering.

 

[D.Hearne]

The 76-79 Granada's didn't have rack and pinion steering. Only the 80-up Fox body Granada's had it.