Having a problem with doors on an '01 gt

Try opening the door and turning that little wheel about half a turn. Works most of the time.

gotta keep those things greased

Wd-40

dont just use wd-40..it comes back in a month...use some grease..i forget what kind..its white...its that roller..it sticks like a mother

I ended up getting new rollers from ford, they were actually revised and had a rubber center section. the factory ones on the car are metalish and tend to get flat.

I am with the guys above, sometimes a good cleaning of the hinges and some WD-40 will cure the problem!

I would put towels all around the hinges and spray them down with brakleen. (Towel off painted areas; brakleen eats paint). I'd clean em up real good, then hose each metal to metal area with White Lithium Grease, or some graphite. I'd rotate the little wheel a little bit, then I'd work the door back and forth a few times. That little excercise worked out every door noise that I had ever come across. Make sure that the door doesn't change height at any position. That could mean a bad hinge. My friend's Cougar would drop about an inch each time you'd open it.

Tomustang: i have been hav'n the same problem for months on my drivers door and i was worried the whole hinge had to be replaced, where and how much did you get the rollers for and how tough was it to install them??

thanks,
ryan