9 96_gtguy New Member Oct 18, 2006 1 0 0 Oct 18, 2006 #1 Oct 18, 2006 #1 I just picked up a set of PI Heads from an '01 GT and need to know how to clean them before I have them installed. Any suggestions? Andy
I just picked up a set of PI Heads from an '01 GT and need to know how to clean them before I have them installed. Any suggestions? Andy
S SmokeMaker New Member Oct 2, 2006 9 0 0 Oct 18, 2006 #2 Oct 18, 2006 #2 When i cleaned my heads on my 96 i ussed a 200 grit sand paper first with engine degreaser. then i used 1000 grit with gas. It worked great smooth!!!! Just don't press down too hard and keep it wet.
When i cleaned my heads on my 96 i ussed a 200 grit sand paper first with engine degreaser. then i used 1000 grit with gas. It worked great smooth!!!! Just don't press down too hard and keep it wet.
M MatthewP Founding Member Dec 7, 2001 355 0 0 Calgary, Alberta Oct 18, 2006 #3 Oct 18, 2006 #3 Use a surfacing disk on an electric drill. Be very careful not to remove any aluminum. -Matthew
