Just installed my new Edelbrock lockwire RPM heads with Felpro's very costly headgaskets at $60.00 a piece AND THEY LEAK in between the lower headbolts. They are torqued to Edelbrock specs and I used ARP bolts.
yes the block was done at a machine shop and is correct. I had the bolt holes taped out to 1/2 inch for better holding power too.
Any ideas? has anyone else had this problem.
yes the block was done at a machine shop and is correct. I had the bolt holes taped out to 1/2 inch for better holding power too.
Any ideas? has anyone else had this problem.