Header to H-Pipe leak??????????

AnthonyR23

Member
Sep 8, 2006
661
0
16
Ontario
Hi, I replaced my old headers for new bbk equal length headers... because I think I had a exhaust leak... which I did in the old headers... but now the ticking sound is still there but just not as loud... I heard a crack when bolting up the old stock h-pipe.. my question is... would a leak at the flange of the old h-pipe to headers... cause a loud tick/squeek..... under load... or is it far enough away from the engine that it shouldn't make that noise??? Any ideas??
 
the cracking sound was more of a popping kinda loud click when I was tightening up the old h pipe.. think it may have just slipped into place... it is just such a pain in the a**... to get up there.. This ticking has been going on for a long time.. but just got louder with time.. the new headers has made it a bit quieter... but I think I could have a problem with the throw out bearing on the clutch... not sure exactly... If it was a exhaust leak... wouldn't it be happening all the time... not just under load.. ??? or I guess the rocking of the engine could make the collector move... where it attaches to the h-pipe.. Seems like the throw out bearing click is hard to find exactly.. kinda nervous putting it up on jacks and running the rear wheels to get it to make that noise.. When I put a crow bar up to the valve covers and can hear a ticking.. but that ticking happens all the time... it's a different noise I think.... more of a squeeking... Is some ticking normal under the valve covers???
 
No I didn't use any high temp silicon.... is that neccessary... I wish there was a way I could tell that ... that is making the noise... before doing anything major.. I am considering purchasing a mac pro chamber but have read on some people's posts that they will actually make the noise louder...
 
i have a leak at the same spot. i had a custom h-pipe made a few years ago. it had a very small leak then. after i installed some mac unequals, the leak got worse. i could not stop the leak because of the way they built the h-pipe. now i'm buying a x-pipe.

to check, start the car when its cold and put your hand around the ball and socket flange. dont actually touch it, just over it. you will feel the air blowing out.