Heading to the machine shop!!

Redsnk95 · Feb 24, 2009

Finally the new project is getting some small progress. I am heading over to the machine shop tomorrow to drop off the block, crank, rods, pistons, balancer, flexplate to get it machined and assembled. The heads and new intake are currently at FTI for work. Man I am dying to get back out there!

SublimeRT · Feb 24, 2009

Nice. How many cubes is it gonna be? What heads/intake? Is it gonna be NA?

Redsnk95 · Feb 25, 2009

352ci (4.065x3.4)..same heads as my old motor. Better intake and much stronger camshaft this time around. Yep still NA.

Stopsign32v · Feb 25, 2009

Why didn't you go 363 and be done with it and what intake are you running? A Vic Jr w/ elbow?

Redsnk95 · Feb 25, 2009

I couldn't pass up on the deal on these particular pistons that I purchased. Victor Sr. intake setup for EFI and using a 4hole throttle body.

Stopsign32v · Feb 25, 2009

You're putting a Super Vic on that? Must not be a car you drive around alot. Should do good in the upper RPMs.

Redsnk95 · Feb 25, 2009

LOL no this has been a track only car for years. Shift points will be around 7800 or so...converter will be around 6800 or so.

YEAHLOH95 · Feb 25, 2009

that sounds awsome can't wait to see how it runs, fti is the way to go good choice.

Redsnk95 · Feb 25, 2009

Lets hope so Troy. We'll see how it works out. Just got all the stock EEC wiring out of the car today, wasn't near as bad as I thought it would be.

Heading to the machine shop!!

Redsnk95

SublimeRT

Member

Redsnk95

Stopsign32v

Member

Redsnk95

Stopsign32v

Member

Redsnk95

YEAHLOH95

Redsnk95

Similar threads

Heading to the machine shop!!

Member

Member

Member

Similar threads

Privacy & Transparency

Privacy & Transparency