• Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech

headlights went out, wont come back on

  • Thread starter Thread starter EIGHTEIGHT_GT
  • Start date Start date Dec 22, 2003

EIGHTEIGHT_GT

Founding Member
May 20, 2001
159
0
0
Tri-Cities,Washington
Dec 22, 2003
#1
  • Dec 22, 2003
  • #1
Hey I lost my headlights on my 99 gt. They used to flicker when the car was cold and I lowered the tilt wheel. They would be on except for the posistion I drive in.Then they would go out, with a little tap on the dash they would come back on.Now I jsut drive with my high beams on. Before I crawl under that thing is there anything I could do? Could the switch be bad? Could it be a fuse?. I dont' have a manual and the fuses arent labeled. As far as I can tell everything else works.Thanks in advance
 

GT2000JAY

Founding Member
Oct 22, 2002
1,344
0
0
Northwest
Dec 22, 2003
#2
  • Dec 22, 2003
  • #2
My suggestion would be to start by going to Ford.com - go to the owners section and register. You can download an owners manual in .pdf format (Adobe Acrobat). You probably want the manual regardless. It will give you the information on fuses.

Now for the bad news. In my opinion, it's probably not a fuse problem. I'm guessing loose connection somewhere in the wiring that finally gave up completely. Electrical is the worlds biggest PITA. Maybe start by removing the headlight knob, the bezel for the instruments and try to check for voltage at the switch. It has two settings - one for parking lights and one for headlights.

You'll need a multimeter to check. Ground the black probe and check each wire on the connector with the other probe. You should see voltage in the on position. A diagram of the connector might be useful, or perhaps someone here can help you out with the exact wiring.

If nothing else, at least this gives you a bump to the top.

Jay
 

Marks5.0!

Founding Member
Jan 27, 2000
640
2
0
San Antonio, TX
Dec 22, 2003
#3
  • Dec 22, 2003
  • #3
fox body gt's had problems with the turn signal/wiper stick going out and it would act just as your describing
 

EIGHTEIGHT_GT

Founding Member
May 20, 2001
159
0
0
Tri-Cities,Washington
Dec 22, 2003
#4
  • Dec 22, 2003
  • #4
Thanks for the info and the bump Jay. Ill dive into it tomorrow
 

stangman

15 Year Member
Jul 10, 2003
2,690
10
69
in a 3 bed, 2 bath
Dec 22, 2003
#5
  • Dec 22, 2003
  • #5
GT2000JAY said:
My suggestion would be to start by going to Ford.com - go to the owners section and register. You can download an owners manual in .pdf format (Adobe Acrobat). You probably want the manual regardless. It will give you the information on fuses.

Now for the bad news. In my opinion, it's probably not a fuse problem. I'm guessing loose connection somewhere in the wiring that finally gave up completely. Electrical is the worlds biggest PITA. Maybe start by removing the headlight knob, the bezel for the instruments and try to check for voltage at the switch. It has two settings - one for parking lights and one for headlights.

You'll need a multimeter to check. Ground the black probe and check each wire on the connector with the other probe. You should see voltage in the on position. A diagram of the connector might be useful, or perhaps someone here can help you out with the exact wiring.

If nothing else, at least this gives you a bump to the top.

Jay
Click to expand...


he's right on with that. good luck finding it, cause like he said electrical problems are a huge pain
 
9

99' GT Stang

New Member
Aug 19, 2003
16
0
0
Marysville, WA
Dec 28, 2003
#6
  • Dec 28, 2003
  • #6
Since you had problems when you tilt your steeringwheel i'd first open the clamshell cover around your column and look for loose/shorted/rubbed through wires...go from there...
 

EIGHTEIGHT_GT

Founding Member
May 20, 2001
159
0
0
Tri-Cities,Washington
Dec 28, 2003
#7
  • Dec 28, 2003
  • #7
Fixed my lights. There were two problems. I did remove the shell around the column. 1) there is wire from a loom that gets pinched when the wheel is tilted.The nearest Quick disconnect to that wasnt even locked in so it would pull them apart. Plugged it. Then 2) The wire from the plug on my dimmer switch that is for low beams was loose. It pulls out becaue the plastic lock that locks the female part into the plug was smaller than the rest so it never locks. Pulled the switch off the the plug and fixed it. Hope that made sense. Luckily it didn't cost anything.
 
You must log in or register to reply here.

Similar threads

1
Electrical Headlight harness trouble
  • 1985fox
  • Apr 14, 2026
  • Fox 5.0 Mustang Tech
Replies
7
Views
237
Fox 5.0 Mustang Tech Apr 17, 2026
AeroCoupe
M
Need help!
  • Masonevans726
  • Dec 17, 2025
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
1
Views
237
1996 - 2004 SN95 Mustang -General/Talk- Dec 17, 2025
Masonevans726
M
1
Electrical 1985 mustang gt Led conversion trouble
  • 1985fox
  • Jan 5, 2026
  • Fox 5.0 Mustang Tech
Replies
10
Views
626
Fox 5.0 Mustang Tech Jan 15, 2026
1985fox
1
W
Headlights dimmer and gauges arent playing nice
  • wmfmike3
  • Aug 30, 2025
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
0
Views
198
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Aug 30, 2025
wmfmike3
W
2
Electrical mayhem
  • 2000ElectricGreen
  • Mar 13, 2026
  • 1996 - 2004 SN95 Mustang -General/Talk-
Replies
2
Views
270
1996 - 2004 SN95 Mustang -General/Talk- Mar 24, 2026
2000ElectricGreen
2
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1996 - 2004 SN95 Mustang -General/Talk-
  • SN95 4.6L Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?