ok I just had my heads milled a good bit .030, It wouldnt run so I shimmed the heads runs awesome now, really hauls ass!! the other night ny lower intake was leaking, like a steady stream out of the intake, and ended up making a damn milkshake in my engine, now today I take it out to drive and I only drove it up to 35mph at the most and 3k rpm and I get back and its leaking again... WTF!!! so now I have another milkshake to clean up, I mean its getting old
so have you guys ever ran into this problem? I used alot less rtv on the heads than I normally do, (this is what I think it is) and as soon as it got up to temp it went to pissing, so im gonna try and get a bigger tube of rtv tomorrow and see if that helps any...
but any input would be good!!
so have you guys ever ran into this problem? I used alot less rtv on the heads than I normally do, (this is what I think it is) and as soon as it got up to temp it went to pissing, so im gonna try and get a bigger tube of rtv tomorrow and see if that helps any...
but any input would be good!!