I guess I really never noticed this before or even payed any attention to this, but should your heater make small shifting sounds when you switch between the settings on the air-flow output selections (right hand knob on heaterpanel)? It also makes similar sounds when you turn the heater on/off. It seems like this would be normal as it sounds like little servos switching directions/closing. Just wondering, since I've been doing some electrical work in the car and I'm hoping this is normal.
On another note, the electrical work that i just did was to install a trunk release button in the glove box area (on the 2" left-hand section of the dash behind the glove box door). I used a trunk release button from a 88GT, so it looks Factory, even says TRUNK RELEASE. Sweet, I no longer have to get out of the car and use the key to open the trunk!
http://www.cherod.com/mustang/HowTo/TrunkRelease.htm
If anyone is interested in doing this, contact me for questions with instructions.
On another note, the electrical work that i just did was to install a trunk release button in the glove box area (on the 2" left-hand section of the dash behind the glove box door). I used a trunk release button from a 88GT, so it looks Factory, even says TRUNK RELEASE. Sweet, I no longer have to get out of the car and use the key to open the trunk!
http://www.cherod.com/mustang/HowTo/TrunkRelease.htm
If anyone is interested in doing this, contact me for questions with instructions.