Help Keep Blowing #6

Cmoney

New Member
Apr 13, 2004
10
0
2
When I turn on my a/c I blow fuse #6. I have looked for obvious shorts and everything looks good.
1992 LX 5.0
Can someone please point me in a direction to start looking?
 
How does the wiring under the hood for the A/C clutch look? I would check it at the LPS and at the WOT relay, and then at the clutch itself.

The wiring at the LPS and WOT relay really vulcanizes - you might find the issue there.

Good luck.
 
I checked the lPS, the WOT, and compressor wiring, but didn't find anything that looked out of place(even untaped them a ways back).
Could the compressor be drawing to much?
Are there any other tests I could do besides ripping my whole car apart, which is probably my next approach?
 
ZephyrMotorspor said:
try putting larger amp fuses in there until you get to a point where it doesn't blow.
Do you hate this guy or have something against him? That's about the worst advice you could give. Maybe he will send you the repair bill for the fire caused by the oversize fuses you recommeded.:nonono:
 
I found the problem, it was the compressor harness with the diode on it. All the wires looked fine, but it has a short in it somewhere. I bought one at the junk yard put the car back together and all was well.


Thanks for the help except ZephyrMotorspor
C