Not for sure if this should be in tech or talk but i'll give it a try here.
Freshly rebuilt '87 302 block
E303 cam
All the typical boltons (see sig)
What i was thinking is to get some AFR 165 heads and hardened pushrods.
Either the BBK ssi upper and lower intake with a 70mm tb OR the edelbrock performer rpm2 upper and lower w/70mm tb I can't decide. Any suggestions?
Also what rocker to go with? 1.6/1.7? brand?
I would like to make a nice streetable mid 11 low 12 car on motor.
Any suggestions welcome, I'm open to ideas from you guys since y'all know more than i do on this subject.:SNSign:
Freshly rebuilt '87 302 block
E303 cam
All the typical boltons (see sig)
What i was thinking is to get some AFR 165 heads and hardened pushrods.
Either the BBK ssi upper and lower intake with a 70mm tb OR the edelbrock performer rpm2 upper and lower w/70mm tb I can't decide. Any suggestions?
Also what rocker to go with? 1.6/1.7? brand?
I would like to make a nice streetable mid 11 low 12 car on motor.
Any suggestions welcome, I'm open to ideas from you guys since y'all know more than i do on this subject.:SNSign: