Help! No Start!

I made a huge mistake the other day. I was clamping on a new hose to the newly installed heater core (HUGE PAIN to install by the way). I clamped down on the hose and somehow got the injector hot wire caught in the clamp and crushed it. I did not notice and tried to start the car. The clamp got cherry red immediately and the car wouldn't start. I removed the clamp to get the crushed wire out and repaired the wire. Now the car will not start at all. I have no spark coming from the coil and I swapped coils with no luck. I cannot hear the fuel pump priming either. I checked all the fuses too. I tested the voltage on the hot injector wire and got a reading of 3.47 vdc. What have I done? I am so ashamed of myself.
:Damnit:
 
Not sure if your wiring layout is the same, but if you follow the wire loom that goes over the strut tower and down under the starter relay you should see the blue link coming out of the loom and curving back up to the relay. If yours has fried you may be looking for stubs of wire.
 
Well, unless you have more than one green link you have the wrong one. There's a green one on there too. A quick looks shows the stock setup should have a 14g green link, a yellow wire with three black 16g black links, a 18g brown link, and a 20g blue link. If the green link has a 18g brown link connected to it then that one goes to the alternator. That's not saying someone could have change a link at some time.