Dropping transmission rn going to double check everything and put a new throw out bearing in cause my old one looks a little beat upHey turtle,did you figure out what's wrong?
Went out while just on the free way clutch just wouldn't engage goes into gear when off,where is the safety switch located? And yes new clutch cable I used the clutch petal to let it set itselfRetrace the steps.
You are saying that it Will not go into gear at all. Was this the issue before you turned the wrench? I am asking this because I am 100% the one who had this same issue. I burnt up a Stage 2 clutch in 26 miles after install........
- Why did you chose to replace the Clutch in the first place? (Diagnosed Correctly?)
- Did you reconnect the Neutral Safety Switch?
- Did you replace anything else? (throw-out bearing, clutch fork, shaft, fluids)
- When you put it all back together, did you mind the proper torque?
- Recheck that damn Safety Switch
- The Clutch Cable, Did you seat it fully at the fork?
- The Clutch Cable, on the firewall is it adjustable or fixed?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?