Help with windage tray and main studs!

[d347644]

I want to run main studs on my new engine im building. I also want to throw a windage tray on there but am NOT going to use a main girdle this time.

Q Who sells a windage tray that bolts to the mains and not a stud girldle?

Q If anyone has this setup what part number studs did you get? How much longer? I would just ask Summit when I order them but lately I've been very dissapointed in the knowledge that their "techs" have..... borderline retarded imo

thank you

Drew

 

[BDASPNY]

bump

 

[352Ford2]

Moroso:

22930: Windage Tray,

24517: Oil Pickup

38191: studs

if you want to look them up on summit put MOR- on the front of the part numbers. I think there is a ARP main stud kit that will work for it, but I can't remeber it off the top of my head.

 

[d347644]

will this work with a stock pan?

 

[2000xp8]

No point in doing a windage tray with a stock pan. Call Canton and they will set you up with similar parts to the moroso.

My canton setup cost around $350. (i think) And i also think i got it from livernois, but it was quite a while ago.
That's a pan, distick+tube, windage tray and all mounting hardware.

 

[d347644]

I hate my canton pan, it leaks. I would order the moroso 7 quarter but its a rear sump only, no front. Hangs too low.

Drew

 

[Realmongo]

MAC makes a tray that fits stock oil pans and comes with the studs to install it. If you buy it off of their website. It is only like $39.00 plus shipping.

 

[352Ford2]

I hate my canton pan, it leaks. I would order the moroso 7 quarter but its a rear sump only, no front. Hangs too low.

Drew

moroso makes T-pans for fox bodys too. go to their website and they have pleanty of options in pan design