• Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech

Hesitation

  • Thread starter Thread starter Racerjoey1
  • Start date Start date Sep 23, 2005
R

Racerjoey1

Founding Member
Oct 21, 2002
76
0
7
Birmingham, AL
Sep 23, 2005
#1
  • Sep 23, 2005
  • #1
Hey when my car is running in the driveway and I rev it up, it kind of hesitates a little. For example if I bring it up to about 2500rpm and then stab it, it takes a second for it to react. Any ideas?

Joey
 

DmnStr8

Member
Apr 16, 2005
0
0
16
NH
Sep 23, 2005
#2
  • Sep 23, 2005
  • #2
Try cleaning your throttle body. Mine was sticking alittle between shifts and had a slight hanging idle. So I decided to get some intake cleaner. I ended up geting the valvoline SynPower stuff as it wasn't much more than the other stuff.

Detach the air intake from the TB. Take some rags and stuff them under the throttlebody to catch run off (there will be a lot). Have a friend sit in your car and hold the throttle down (with it off ) if you can't get help you can work the plate by hand but this can be a PITA if you need to scrub any spots. Next spray the crap (literally) out of the throttle body. Use a rag or a toothbrush to get the more stubborn stuff. You should get some nasty stuff running out of the TB. Next have your friend pump the gas slowly so you can spray the TB plates pivot (lots of crap gets stuck in here and moving the plate back and forth really seemed to work it out for me). Try to wipe what you can clean and dry and reattach the airduct.

Afterwards the car might have trouble starting due to all the cleaner and junk thats in the intake. Mine took about 30 secs and then ran real rough (like shaking the car rough)for about 5 mins. Afterwards I went for a short drive to help pull all the crap out of my intake.

I saw a huge improvement in my cars performance. Leaving the driveway I gave it a little to much and left a nice patch. My RPMS still hang a bit so next I'm going to tackle the IAC and EGR.

Hope this helps. Costs about 3 bucks and takes about 30 min.
 
You must log in or register to reply here.

Similar threads

Engine Coolant boiling in hose?
  • Teen'93stang5.0
  • Jun 3, 2026
  • Fox 5.0 Mustang Tech
Replies
7
Views
340
Fox 5.0 Mustang Tech Jun 8, 2026
Mustang5L5
1
Engine 91 mustang 302 Low acceleration car backfires pops and acts like it doesn’t want to take fuel
  • 1991Fox5.0
  • Oct 4, 2025
  • Fox 5.0 Mustang Tech
Replies
16
Views
1K
Fox 5.0 Mustang Tech Oct 6, 2025
1991Fox5.0
1
P
Repeated P2004 DTC trouble code with no apparent symptoms
  • poehitman
  • Mar 11, 2026
  • SN95 V6 Mustang Tech
Replies
2
Views
307
SN95 V6 Mustang Tech Mar 12, 2026
poehitman
P
Surging/stalling! problem or tune?
  • djj62478
  • Oct 4, 2026
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
Replies
11
Views
387
1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk- Oct 14, 2026
KRUISR
C
Engine Idle cuts out
  • claypoolxx
  • Mar 7, 2026
  • Fox 5.0 Mustang Tech
  • 2
Replies
25
Views
1K
Fox 5.0 Mustang Tech Jul 24, 2026
alutwon
Share:
Bluesky Email Share Link
  • Mustang Forums
  • 1979 - 1995 (Fox, SN95.0, & 2.3L) -General/Talk-
  • Fox 5.0 Mustang Tech
Menu
Log in

Register

  • Forums
  • What's new
  • Media
  • Resources
  • Contact
  • Sponsor
X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?

X

Privacy & Transparency

We use cookies and similar technologies for the following purposes:

  • Personalized ads and content
  • Content measurement and audience insights

Do you accept cookies and these technologies?