I did the 5.0L conversion into my 68 with the AOD. I had to shelve the project for a few years due to two separate family illnesses. Now broke and needing to move the stang, I am trying to get it started with no luck.
Symptoms: Cranks and starts, but will die after about 10-15 seconds unless feathering the throttle. When doing this, it also pops thru the intake I think, and the exhaust smells of gas. I have tried to adjust the timing per instructions from JRinker's posts. So now I am looking at other issues. Because the SOB that sold me the engine screwed me in the beginning, I am working with what I can only surmise to be an 89 Lincoln harness, so most of the wire colors or locations were all messed up. There is a test port, with the single wire gray plug but again the wire colors are all off and the locations in the plug are diff too. Nightmare to say the least.
To be perfectly honest, I have no idea what I did to get it running in the first place. LOL It has been too long and my notes are missing. So I figure I will test the computer first and work back to the engine sensors.
One note is that I do not have any of the smog components, and TAB/TAD, and a few other sensors are just hanging unplugged. I do have the EGR, TPS, Air bypass, Baro, Exh. O2 sensors, ACT in #5 runner of Explorer intake, all connected. How do I tell if those sensors I have connected are good?
Question is, do I need to have some kind of resistors or dead end plugs for the sensors not connected? Will these cause problems with drivability if not used? I have no way of putting the smog stuff back on as it all went to the recycling company years ago.
Thanks for the help if you can.
Symptoms: Cranks and starts, but will die after about 10-15 seconds unless feathering the throttle. When doing this, it also pops thru the intake I think, and the exhaust smells of gas. I have tried to adjust the timing per instructions from JRinker's posts. So now I am looking at other issues. Because the SOB that sold me the engine screwed me in the beginning, I am working with what I can only surmise to be an 89 Lincoln harness, so most of the wire colors or locations were all messed up. There is a test port, with the single wire gray plug but again the wire colors are all off and the locations in the plug are diff too. Nightmare to say the least.
To be perfectly honest, I have no idea what I did to get it running in the first place. LOL It has been too long and my notes are missing. So I figure I will test the computer first and work back to the engine sensors.
One note is that I do not have any of the smog components, and TAB/TAD, and a few other sensors are just hanging unplugged. I do have the EGR, TPS, Air bypass, Baro, Exh. O2 sensors, ACT in #5 runner of Explorer intake, all connected. How do I tell if those sensors I have connected are good?
Question is, do I need to have some kind of resistors or dead end plugs for the sensors not connected? Will these cause problems with drivability if not used? I have no way of putting the smog stuff back on as it all went to the recycling company years ago.
Thanks for the help if you can.