how did everyone wire there electric fuel pump on carb setup?

[95conv5.0]

how did everyone wire it? thanks

 

[EMW150]

I wired mine with a direct feed from the battery to a remote fusebox, then to a relay, then to the pump. You can energize the relay either with a toggle switch or ignition key. Here's the type of relay you need: Just an example, you can probably find a cheaper one.

http://store.summitracing.com/largeimage.asp?part=EDL-1795

 

[thehueypilot]

I reused all the original wiring and jumped the computer wiring and added a relay (at the computer location) to turn it on and off with a switch instead of it running as soon as you turn the key on. I wanted to retain the rollover switch in the back just in case, plus all the wiring was already run to the pump from the factory.

 

[jrichker]

I reused all the original wiring and jumped the computer wiring and added a relay (at the computer location) to turn it on and off with a switch instead of it running as soon as you turn the key on. I wanted to retain the rollover switch in the back just in case, plus all the wiring was already run to the pump from the factory.

Best plan yet! Excellent idea.

 

[86bluecobra]

Stole power from ignition so when key turns on so does pump.

 

[85ragtop]

I did what most of them did, but I hooked up a Holley oil pressure sensor. It will not turn on the fuel pump until it has oil pressure.