How to wire fog light switch to 248a 96gt?

[justinschmidt1]

My 96 gt is a 248 with no fogs stock.

it has the wires to plug the fogs in, the relay/fuse is there for the horn, so I think the last step to get these to turn on would be wiring a switch and replacing one of the coin holders right?

Where should this switch be wired too?

 

[mustang50v8]

in theory, if the wire harness is up front for the fogs, the harness should be there for the switch. just look around in there.


then again...it is a ford. so it probably isnt there. in that case i cant help you. it was many years and untold amounts of alcohol ago when i wired my v6 for foglights.

 

[justinschmidt1]

in theory, if the wire harness is up front for the fogs, the harness should be there for the switch. just look around in there.


then again...it is a ford. so it probably isnt there. in that case i cant help you. it was many years and untold amounts of alcohol ago when i wired my v6 for foglights.

Im just trying to figure out what I need for fog lights to work on my car

 

[8111870]

the switch does replace the coin holder and gets tapped into the
headlight wire under the drivers dash i dont remember the color
but you could go to your ford dealer and ask for a foglight kit (if theyre still available) it has detailed install instructions, just photocopy them.
good luck
PS i have a 96 248a too (opal frost)