Ignition Lock Cylinder Removal, 70 Mach I??

horseballz · Oct 21, 2012

Is there a way to remove the ignition lock cylinder WITHOUT destroying the steering column? We do not have the key. Local locksmith says he can make us a key from the door lock cylinder (easily removed) for $60, but that's a $60 gamble/hunch/hope that the doors still match the ignition after 42 years.View attachment 142228 Any and all help/suggestions would be truly appreciated. FWIW, we have already tried the 50 some odd "extra" keys we have in a box, wiggling, etc, to see if we could find a close match, but no luck.
Thanks,
Gene

horse sence · Oct 21, 2012

Gene , i have drilled the centers out before using about a 5/16 bit. just drill deep enough to get to the tumbler pins and there springs out . you will still have to use a straightend out paper clip to push the release to pull the lock part out . works on trunk locks and door locks as well .just dont drill to deep. Jim

horseballz · Oct 21, 2012

Thanks for confirming my intention/plan/assumption.
Gene

woodsnake · Oct 21, 2012

On my 71, I removed the steering wheel, down to the top of the column, and was able to get it to release with a pick tool from there...Have you looked at that option?

horseballz · Oct 22, 2012

Old cylinder drilled out, new one in, all is good! Didn't have a chance to attempt the release with a pick tool. as my helper already had it done.
Thanks,
Gene

horse sence · Oct 22, 2012

yeah that cordless craftsman key usually does the trick.

Ignition Lock Cylinder Removal, 70 Mach I??

horseballz

horse sence

horseballz

woodsnake

horseballz

horse sence

Similar threads

Privacy & Transparency

Privacy & Transparency