ignition problems please help

If you can get the ignition to turn you don't even have to pull the steering wheel just the steering column shrouds.

If the key won't turn.

Mitchells on Demand says. You have to remove the steering wheel as well as the shrouds on the steering column. Use a1/8th inch drill bit to drill out the retaining pin (you would be able to just push this pin in if the key rotated) but DO NOT drill deeper than 1/2 inch. Use a hammer and chisel to break off the end cap off. Then use a 3/8 inch drill bit and drill down the middle of the lock cylinder key slot about 1 3/4" inches until the lock cylinder breaks loose. Then remove the lock retainer, washer and cylinder gear from housing. Clean up all the shavings and install the new lock.

Good Luck and let us know how you make out